Manual Device Setup for Windows

This article sets up your  Windows PC to use the Wi-Fi network of your home router, while streaming traffic is routed to the StreamLocator router so that the streaming relocation service is in effect.

Note that this set-up process is an advanced configuration of your local connection, so some technical experience will be required. 

Step 1:

On your main router admin console, create an  IP reservation for your Computer - this is usually in the LAN settings or DHCP setting. **Important - when creating the IP reservation, write down the internal IP address of the computer.

Step 2:

Visit my.streamlocator.com from any device, click your email at the top right and select Advanced Settings. Look for the Advanced Connection Options tab on the bottom and take note of the addresses for later.

Step 3:

In Windows go to Control Panel > Network and Internet > Network and Sharing Center  > Your Ethernet (Wire) or Wireless (Wi-Fi) Adapter > Properties > Double click Internet Protocol Version 4 (IPv4) 

In the following menu configure like so and click OK:

**Under IP address enter the address we found when making the IP reservation in Step 1.